HP AlphaServer ES47 User Manual

Commands
Chapter 3
Commands
3.1 Command Summary
Command Function
assign {component, memory} Assign resources to a partition.
bootline Change the bootline used in boot ROMs.
build fru Write FRU-specific information to a FRU’s
EEPROM.
clear {<envar>, alert, display, error, log,
port, srmenv}
Clear the SPMU environment variable, the 'alert
pending’ flag, all error fields in the specified
FRU, the screen or serial port, or SRM
environment variables for all partitions, for a
specific hard partition, or for a specific
subpartition within a hard partition.
config cables Configure or assist cabling.
connect Connect to the system COM port of a partition.
create partition Create a hard or subpartition.
delete partition Delete a hard or subpartition.
deposit or d Write data to a memory location or CSR, IPR,
or I
2
C device
disable {
alert, remote, test} Disable the sending of alerts, remote access, or
a diagnostic test
el Event log - show the history of CLI inputs and
outputs.
enable {
alert, remote, test} Enable the modem dial-out alert function,
remote access to the system, or a diagnostic
test.
examine or e Read a memory location or CSR, IPR, or I
2
C
device.
halt {
in, out} Halt the entire system, CPU, or partition.
hangup Terminate the modem or telnet connection.
help Display the entire list of CLI commands.
init modem Initialize the modem.
locate Locate the specified component (system
building block, PCI drawer, dynamic duo, or
power supply) by blinking its LEDs.
logout Log out of the remote host.
mbmboot or @ (Works only from the failsafe loader.) Boots the
main MBM/PBM image from flash or from the
network.
modify partition Changes the attributes of a hard partition.
power {
off, on} Power off or on a system, component, or
partition.
reset Reset a system, CPU, or partition.
save partition Save the partition data to the NVRAM.
3-1

HP AlphaServer ES47 Specifications

General

Brand	HP
Model	AlphaServer ES47
Category	Server
Language	English