key-id
Set the authentication key to use for this server.
max-poll <max-poll-val>
Configure the maximum time intervals in seconds.
min-poll <min-poll-val>
Configure the minimum time intervals in seconds.
ntp ipv6-multicast
This command is used to configure NTP multicast on a VLAN interface.
Syntax
ntp ipv6-multicast
Description
Configure the interface to listen to the NTP multicast packets.
Example
Switch(vlan-2)# ntp
ipv6-multicast Configure the interface to listen to the NTP multicast packets.
Restrictions
Validation Error/Warning/Prompt
If ipv6 is not enabled on vlan interface
IPv6 address not configured on the
VLAN.
debug ntp
This command is used to display debug messages for NTP.
Syntax
debug ntp <event |
packet>
Options
event
Displays event log messages related to NTP.
packets
Displays NTP packet messages.
Description
Enable debug logging. Use [no] to disable debug logging.
Example
Switch(config)# debug ntp
event Display event log messages related to NTP.
packet Display NTP packet messages.
ntp trap
This command is used to configure NTP traps.
56 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General