HP Broadband Series - Connecting to an Optical Line Interface

Getting Started
Overview
2-4
Connecting to an Optical Line Interface
Before measurements are made, connect the Electrical Interface to the optical
line interface module using RF cables with an SMA connector on one end and an
SMB connector on the other. Connections are shown in Figure 2.1.
Figure 2.1 Interconnecting the modules
HP E1663A
SONET/SDH
Electrical Interface
HP E1697A Optical Line
Interface or HP E1617A
Optical Line Interface
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com