ENWW Using the Embedded Web Server 117
Authentication
Behavior:
Reauthenticate
on Apply
Enable (check) or disable (clear) this checkbox to control
authentication when you click Apply on this page, assuming valid
configuration entries have been made.
Note: This parameter does not apply to security or wireless
configuration wizards. Changes to wireless parameters
through a wizard will always cause the print server to
reauthenticate.
If disabled (default), the print server will not attempt
reauthentication unless configuration changes cause the print
server to disconnect and reconnect to the network.
If enabled, the print server will always try to reauthenticate using
the configuration values set.
EAP/PSK Select Extensible Authentication Protocol Pre-Shared Key
(EAP/PSK) for advanced authentication. EAP/PSK is typically for
small networks where authentication servers are not used. If
EAP/PSK authentication is selected, you will need to enter a
network pass-phrase that is used to generate the pre-shared key
for your network.
Pass-phrase Enter a network pass-phrase that will be used to generate the
pre-shared key for EAP/PSK authentication on your network.
A pass-phrase must be from 8 to 63 ASCII characters in the
hexadecimal range 21 through 7E (characters 0-9, a-z, A-Z and
numerous special characters including !, @, #, $, %, ^, &, (, ), _,
+, =, -, {, }, [, ], \, /, “, <, >, ?, “, ‘, ~).
Disabled (No
encryption)
Select Disabled (No encryption) if your wireless network does
not use encryption keys for network access or communications.
Enabled Select Enabled to use your encryption settings specified below
for network access and communications.
Table 4.3 802.11B Configuration Parameters (5 of 7)
Item Description
To Next Page
Loading...
Need help?
General
