ENWW Using the Embedded Web Server 142
Custom Security This option proceeds through all available security settings
supported by your print server. For more information on
specific parameters and selections, see the tabs on the
Mgmt. Protocols
and Authorization menu pages under
SECURITY.
The Administrator Account page is used to enter the
administrator password.
The Web Mgmt. page (for full-featured print servers only)
is used for HTTPS (secure HTTP) configuration, including
certificates and encryption levels.
The Management Tools page allows configuration of
management protocols that are not secure (such as RCFG,
Telnet and FTP firmware updates).
SNMP Configuration pages are used to configure specific
SNMP settings:
● Enable SNMPv1/v2: Enable this option to allow
management software that use SNMP v1/v2. If selected
the SNMPv1/v2 Configuration page is displayed to
configure SNMP community names.
● Enable SNMPv3: (Full-featured print servers only)
Enable this option to create an SNMP v3 account.
Creating an SNMP v3 account is not recommended if
you manage devices using HP Web Jetadmin. See
SNMP
.
The Authorization page is used to set up an Access
Control List, if desired to control host access to the device.
The Print Protocols and Services page is used to enable
or disable network printing, print services, and device
discovery protocols that may affect security.
The Configuration Review page displays all the current
settings that may affect security. Click Finish to set your
basic security selections.
Table 4.11 Wizard Security Levels (2 of 2)
Security Level Description
To Next Page
Loading...
Need help?
General
