ENWW Configuring for LPD Printing 164
10. Click OK and select Exit from the List menu.
11. Select Exit Sam.
Note By default, the lpsched is not running. Make sure
you turn the scheduler on when you set up your
print queues.
Printing a Test File
To verify that the printer and print server connections are correct,
print a test file.
1. At the UNIX system prompt type:
lpr -Pprinter_name file_name
where printer_name is the designated printer and
file_name refers to the file to be printed.
Examples (for BSD-based systems):
Text File: lpr -Ptext1 textfile
PCL File: lpr -Praw1 pclfile.pcl
PostScript File: lpr -Praw1 psfile.ps
HP-GL/2 File: lpr -Praw1 hpglfile.hpg
For HP-UX systems, substitute lp -d for lpr -P.
2. To get print status, type the following at the UNIX prompt:
lpq -Pprinter_name
where printer_name is the designated printer.
Examples (for BSD-based systems):
lpq -Ptext1
lpq -Praw1
For HP-UX systems, substitute lpstat for lpq -P to get print
status.
This completes the process for configuring the HP Jetdirect print
server to use LPD.
To Next Page
Loading...
Need help?
General
