HP C8088B Administrator's Guide

ENWW The HP Jetdirect Control Panel Menu 288
MANUAL SETTINGS (Available only if CONFIG METHOD is set to
MANUAL) Configure parameters directly
from the printer control panel:
● IP ADDRESS n.n.n.n: The unique IP
address of the printer, where n is a value
from 0 to 255.
● SUBNET MASK m.m.m.m: The subnet
mask for the printer, where m is a value
from 0 to 255.
● SYSLOG SERVER n.n.n.n: The IP
address of the syslog server used to
receive and log syslog messages.
● DEFAULT GATEWAY n.n.n.n: The IP
address of the gateway or router used for
communications with other networks.
● IDLE TIMEOUT: The time period, in
seconds, after which an idle TCP print
data connection is closed (default is 270
seconds, 0 disables the timeout).
DNS SERVER (620n Only) Specify the IP address (n.n.n.n)
of the DNS Server.
IPX/SPX ENABLE ON: Enable the IPX/SPX protocol
OFF: Disable the IPX/SPX protocol
FRAME TYPE Selects the frame type setting for your
network.
AUTO (default): Automatically sets and limits
the frame type to the first one detected.
EN_8023, EN_II, EN_8022, EN_SNAP:
Frame type selections for Ethernet
networks.
TR_8022, TR_SNAP: Frame type selections
for Token Ring networks.
SOURCE ROUTING (Token Ring only) Specify the
NetWare
Source Routing
parameter
AUTO (default): The type of source routing
required on the network is automatically
sensed
OFF: All packets are sent without source
routing, and only packets from the same
ring are received.
ALL ROUTES and SINGLE ROUTES: All
packets are sent with source routing
(broadcasts, and when the route is
unknown)
Table C.2 HP Jetdirect Graphical Control Panel Menu (6 of 7)
Menu Item Options Description of settings

HP C8088B Specifications

General

Brand	HP
Model	C8088B
Category	Printer Accessories
Language	English