HP C8088B Administrator's Guide

ENWW TCP/IP Configuration 84
server-auth This command requires that you specify a dynamic
encryption option (dynamic-encrypt command) and EAP
802.1x authentication (wpa-auth-type command). Use
this command to specify server-based authentication
methods used on your network. For a brief description of
supported authentication protocols, see Chapter 1
.
None: (default) Server-based network authentication is not
used.
EAP_MD5: An authentication method that uses 802.1x EAP
and MD5 (Message-Digest Algorithm 5, RFC 1321). It
requires that a user name and password be configured on
the device. Use the svr-auth-user and
svr-auth-pass commands to specify a user name and
password, respectively.
EAP_TLS: An authentication method that uses 802.1x
EAP-TLS (Extensible Authentication Protocol - Transport
Layer Security, RFC 2716). It requires a user name and an
installed X.509-compliant digital certificate for device
validation. In addition, a CA (Certificate Authority) certificate
used to validate the authentication server must be installed.
Use the svr-auth-user command to specify a user name.
To install certificates, use the embedded Web server. See
Chapter 4
.
LEAP: An authentication method that uses LEAP
(Lightweight Extensible Authentication Protocol). LEAP is a
Cisco Systems, Inc. proprietary protocol. LEAP requires a
user name and password. Use the svr-auth-user and
svr-auth-pass commands to specify a user name and
password, respectively.
PEAP: An authentication method that uses PEAP
(Protected Extensible Authentication Protocol). PEAP
requires a user name and password for client validation. In
addition, a CA (Certificate Authority) certificate used to
validate the authentication server must be installed. Use the
svr-auth-user and svr-auth-pass commands to
specify a user name and password, respectively. To install
certificates, use the embedded Web server. See Chapter 4
.
EAP_TTLS: An authentication method that uses TTLS
(Tunneled Transport Layer Security). EAP-TTLS is an
EAP-TLS extension that also uses X.509-compliant digital
certificates. TTLS requires a user name and password for
client validation. In addition, a CA (Certificate Authority)
certificate used to validate the authentication server must be
installed. Use the svr-auth-user and svr-auth-pass
commands to specify a user name and password,
respectively. To install certificates, use the embedded Web
server. See Chapter 4
.
svr-auth-user Specify a user name for server-based authentication. Up to
128 alphanumeric characters may be used.
Table 3.4 Telnet Commands and Parameters (4 of 18)

HP C8088B Specifications

General

Brand	HP
Model	C8088B
Category	Printer Accessories
Language	English