h. If it is necessary to replace the display panel bracket, remove the bracket.
The display panel bracket is available using spare part number L14337-001.
12. If it is necessary to replace the display back cover:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the following screws that secure the back cover to the display hinges:
(1) Two Phillips M2.0×2.8 screws on the back cover top edge
(2) Four Phillips M2.0×3.0 broad head screws on the display hinge outside edges
(3) Two Phillips M2.5×4.7 screws on the display hinge inside edges
d. Release the display panel (4) as far as the webcam/microphone module cable allows.
e. Release the webcam/microphone module cable (5) from the retention clips and routing channel built
into the display back cover.
46 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
