Fingerprint sensor board
To remove the ngerprint sensor board, use this procedure and illustration.
Table 5-6 Fingerprint sensor board description and part number
Description Spare part number
Fingerprint sensor board (includes cable) M35757-001
Fingerprint sensor bracket (available in the Bracket Kit) M12524-001
Before removing the ngerprint sensor board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the bottom cover (Bottom cover on page 22).
3. Remove the battery (see Battery on page 23).
Remove the ngerprint sensor board:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the ngerprint sensor bracket.
2. Lift the bottom of the bracket up, and then pull bracket toward front and out from under lip at the top of
the bracket (2).
3. Disconnect the cable from the ZIF connector on the system board (3), and then peel the cable o the
computer.
4. Remove the ngerprint sensor board and cable from the computer (4).
Reverse this procedure to install the ngerprint sensor board.
Fan
To remove the fan, use this procedure and illustration.
28 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
