Printing
Use the HP ToolboxFX printing settings options to configure the settings for all print functions. These
are the same options that are available on the Print settings menu on the control panel.
NOTE Click Apply to make the changes take effect.
PCL5c
Configure these PCL5c settings:
●
Font number
●
Font pitch
●
Font point size
●
Symbol set
●
Append CR to LF
●
Form length
PostScript
Use the PostScript option when using the PostScript print personality. When the Print PostScript
error option is turned on, the PostScript error page automatically prints when PostScript errors occur.
NOTE Click Apply to make the changes take effect.
Memory card (HP Color LaserJet CM1017 MFP only)
Use the three HP ToolboxFX memory card options to configure print settings when using memory
cards.
●
Enable memory cards. Enable or disable memory-card functionality.
●
Photo image size. Select the size photos to print from the drop-down list.
●
Photo number of copies. Type the number of copies from 0 to 99 to print for each image.
●
Photo output color. Select either Color or Monochrome from the drop-down list.
Click Apply to save the settings.
Network settings
The network administrator can use the HP ToolboxFX Network Settings folder to control the
network-related MFP settings when it is connected to an IP-based network.
The settings are:
●
IP Configuration
●
Advanced
ENWW Management tools 41
To Next Page
Loading...