HP CM1312nfi - Color LaserJet MFP Laser

Figure 5-12 Restart alert
Click Restart to close the installer and restart the computer. After the computer restarts, you must log
in to the computer, and then the HP Setup Assistant starts automatically.
NOTE: If the HP Setup Assistant does not start automatically, follow these steps:
1. Click Macintosh Hard Drive.
2. Click Applications.
3. Click HP.
4. Double-click HP Setup Assistant.
Figure 5-13 HP Setup Assistant – Introduction
Click Next to go to the Select Device dialog box.
ENWW Macintosh install instructions 231
Macintosh software and
utilities