High-voltage power supply upper
Before proceeding, remove the following components:
●
Formatter PCA. See
Formatter PCA on page 192.
●
Right-rear cover. See
Right-rear cover on page 231.
●
Left cover. See
Left cover on page 233.
●
Rear-upper cover. See
Rear-upper cover on page 236.
●
Rear cover. See
Rear cover on page 238.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 267.
●
DC controller. See
DC controller PCA and tray on page 270.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 273.
Remove the high-voltage power supply upper
CAUTION: ESD-sensitive part.
1. Remove one screw (callout 1).
Figure 6-255 Remove the high-voltage power supply upper (1 of 5)
1
ENWW Internal assemblies 339
To Next Page
Loading...
