2. Remove four screws (callout 2), and then rotate the sheet-metal plate away from the power supply.
NOTE: You do not need to completely remove the sheet-metal plate to access the power supply.
Figure 6-256 Remove the high-voltage power supply upper (2 of 5)
2
3. Disconnect two connectors (J201, J202; callout 3) from the back side of the power supply.
NOTE: For clarity, the figure in this step shows the ADF and scanner removed. Carefully reach
under these components to access the two connectors.
Figure 6-257 Remove the high-voltage power supply upper (3 of 5)
3
340 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...
