Control panel message Description Recommended action
●
Reduce the number of
originals.
●
Reset the fax settings to
factory defaults. Configure
only the basic settings
needed to operate: country/
region, company name, and
fax number.
●
Verify that the fax card
firmware revision is the
correct version for the
formatter firmware version on
the product.
c. If the error occurs only when
printing a job, try the following
actions:
●
Verify that the printer driver is
correct for your product.
●
Try printing another file from
the same software program
or from another software
program.
●
Reduce the number of
features being used in the
print job, such as printing
watermarks, printing multiple
pages on one sheet, or using
job-storage features.
●
If other files or software
programs are successful, try
making changes to the file,
such using different fonts,
changing driver settings, or
printing with another driver
language, such as PCL 6.
d. If the error continues to occur,
update the product firmware.
Obtain the latest firmware from
www.hp.com/go/
cljcm3530mfp_firmware.
3. If the error persists after performing
these steps, contact your Hewlett
Packard support center.
50.1 FUSER ERROR The fuser has experienced a low-
temperature error.
1. Remove any paper jams from the fuser
area.
2. Remove the fuser. Check the connector
(J50) between the fuser and the
product. Replace the cable or fuser if the
connector is damaged.
3. If the problem persists, replace the
fuser. See
Fuser on page 200.
Table 7-12 Control-panel messages (continued)
ENWW Control-panel messages 447
To Next Page
Loading...
