Control panel message Description Recommended action
and Reboot, but it does not restart
the product.
Image CRC error This message is displayed before the
firmware is loaded at startup when an error
occurs during a firmware upgrade.
Resend the upgrade.
Incompatible fuser The wrong fuser is installed. The product will
not print, even though the fuser fits the
product.
Install the correct fuser. See Fuser
on page 200.
Incompatible supplies Two or more incompatible supplies are
installed. The product will not print, even
though the supplies fit the product.
Install the correct supply.
INFLATE FAILURE An error occurred during the firmware
upgrade.
Resend the upgrade.
Initializing permanent storage Product is initializing permanent storage. No action is necessary.
Initializing scanner The scanner is initializing. Wait until the scanner is Ready before
proceeding to scan.
Install <color> cartridge The print cartridge has been removed or has
been installed incorrectly.
Replace or reinstall the print cartridge
correctly to continue printing.
Install fuser The fuser is either not installed or not installed
correctly.
Install the fuser. See Fuser on page 200.
Install supplies At least two supplies are missing. Replace the missing supplies or make sure
the installed supplies are fully seated.
Install transfer unit The ITB is either not installed or not installed
correctly.
Replace the ITB. See Intermediate transfer
belt (ITB) on page 209.
Insufficient memory to load fonts/data
<device> To continue touch OK
The product does not have enough memory
to load the data (for example, fonts or
macros) from the location specified.
Touch OK to continue without this
information. If the message persists, add
memory.
Internal Disk Device Failure - To Clear
Touch OK
The specified device failed. Touch OK to clear the message.
Internal disk file operation failed To clear
touch OK
A PJL file system command attempted to
perform an illogical operation, such as
downloading a file to a non-existent directory.
Touch OK to clear.
Internal Disk Initializing The internal disk is initializing. No action is necessary.
Internal disk is write protected To clear
touch OK
The product is protected and no new files can
be written to it.
Touch OK to clear the message.
Internal disk not found Internal disk not found. Turn the product off and then on.
Internal disk not functional The internal disk is not functional. Copy and send is disabled. Turn the product
off and then on.
Internal disk not initialized The internal disk is not initialized. Initialize the disk.
Internal disk spinning up The internal disk is spinning up its platter. It
usually shows for approximately 15 seconds
when the product comes out of power-save
mode. Jobs can still print, but jobs that require
disk access (i.e., stored jobs) must wait.
No action is necessary.
Table 7-12 Control-panel messages (continued)
ENWW Control-panel messages 459
To Next Page
Loading...
