Control panel message Description Recommended action
Replace Supplies - Using black A color supply (or supplies) has reached the
out condition and the Color Supply Out menu
item is set to Autocontinue black.
No user input is required for printing to
continue. Printing continues in black.
Replace transfer kit The supply has reached the end of life.
Printing can continue.
Replace transfer kit. See Intermediate
transfer belt (ITB) on page 209.
Replace transfer kit To continue, touch
OK
The transfer kit is at the end of life. Printing
can continue, but print quality might be
reduced.
The product is set to stop printing when a
supply needs to be ordered. To continue
printing, touch OK.
Replace the ITB. See
Intermediate transfer
belt (ITB) on page 209.
Request Accepted Please Wait This message appears when a request to
print an internal page is accepted but cannot
print.
Wait for the internal page to print.
Resend external accessory firmware An external accessory requires a firmware
upgrade. Printing can continue, but jams may
occur if the job uses the external accessory.
Perform a firmware upgrade.
Resend upgrade A firmware upgrade did not complete
successfully.
Upgrade the firmware again.
Restoring factory settings A Restore Factory Settings reset is being
performed.
No action is necessary.
Restoring… A Restore Last Saved State, Restore Print
Modes, Restore Optimization, or Restore
Color Values operation is being performed.
No action is necessary.
Restricted from printing in color The print job is being forced to print in black
either because the product is set to print only
in black or because the user ID and
application ID do not have color printing
permissions.
No action is necessary.
RFU LOAD ERROR A failure occurred during the remote firmware
upgrade.
Resend the upgrade.
ROM Disk Device Failure - To Clear Touch
OK
The specified device failed. Touch OK to clear.
ROM Disk file operation failed To clear
touch OK
A PJL file system command was received
that attempted to perform an illogical
operation, such as downloading a file to a
non-existent directory.
Touch OK to clear the message.
ROM Disk is write protected To clear
touch OK
The device is protected and no new files can
be written to it.
Touch OK to clear the message.
ROM Disk Not Initialized The file system device must be initialized
before it can be used.
Initialize the device.
Rotating <color> Motor A component test is in progress; the
component selected is the <color> cartridge
motor.
Press Stop to stop the test.
Rotating Motor - To exit press STOP The product is executing a component test
and the component selected is a motor.
Press Stop to stop the test.
Sanitizing Disk <X>% Complete Do not
power off
The hard disk is being cleaned. Contact the network administrator.
Table 7-12 Control-panel messages (continued)
464 Chapter 7 Solve problems ENWW
To Next Page
Loading...
