Control panel message Description Recommended action
Unsupported data on [FS] DIMM in slot The data on the DIMM is not supported. The DIMM may need to be replaced. Turn off
the product before removing it. To clear this
warning, touch OK.
Unsupported USB accessory detected The USB accessory is not recognized and
cannot be used by this product.
Remove the USB accessory. To clear this
message, touch OK.
Upgrade complete To continue, turn off
and then on
Upgrade complete. Turn the product off and then on.
USB ACCESSORY UNAVAILABLE The USB accessory was installed after the
product was turned on. The product does not
support plug-and-play operation.
1. Remove the USB accessory.
2. Turn the product off, and then plug in the
USB accessory.
3. Turn the product on.
USB Device Failure - To Clear Touch OK The specified device failed. Touch OK to clear.
USB file operation failed To clear touch
OK
A PJL file system command was received
that attempted to perform an illogical
operation, such as downloading a file to a
non-existent directory.
Touch OK to clear the message.
USB HUBS NOT FULLY SUPPORTED Some USB hubs require more power than the
product has available.
1. Remove the USB hub.
USB is write protected To clear touch OK The device is protected and no new files can
be written to it.
Touch OK to clear the message.
USB needs too much power Power requirements for the USB accessory
attached to this product are beyond
supported limits.
Detach the accessory, and then turn the
product off and then on. Try a similar
accessory that has its own power supply or
requires less power.
USB Not Initialized The file system device must be initialized
before it can be used.
Initialize the device.
USB storage <X> is initializing The designated USB storage unit is
initializing.
No action is necessary.
USB storage <X> is not functional A parameter in the USB storage is not
working correctly.
Turn the product off. Disconnect the USB
storage accessory, and replace with a new
USB storage accessory.
USB storage <X> removed A USB storage accessory has been
disconnected since the product was turned
on.
To continue using the USB accessory, turn
the product off and reconnect it. Turn the
product off and then on to clear the message.
USED SUPPLY IN USE One or more used supplies have been
installed.
1. Install new supplies.
2. If you believe you purchased a genuine
HP supply, visit us at
www.hp.com/go/
anticounterfeit. Any repair required as a
result of using used cartridges is not
covered under warranty. Supply status
and features depending on supply
status are not available.
Wait for printer to reinitialize The user changed the RAMDISK settings.
The product automatically restarts.
No action is necessary.
Waiting for tray <XX> to lift The tray number specified by <XX> is in the
process of lifting the paper to the top of the
tray for proper feeding.
No action is necessary.
Table 7-12 Control-panel messages (continued)
466 Chapter 7 Solve problems ENWW
To Next Page
Loading...
