Service mode functions
Service menu
The Service menu is PIN-protected for added security. Only authorized service people have access to
the Service menu. When you select Service from the list of menus, the product prompts you to type an
eight-digit PIN number. The PIN for the HP Color LaserJet CM3530 MFP Series is 11353008.
NOTE: The product automatically exits the Service menu after about one minute if no items are
selected or changed.
1. Scroll to and touch Administration.
2. Scroll to and touch Service.
3. Touch the Service use only: text box near the center of the control-panel display. The touchscreen
numeric keypad appears.
4. Touch the touchscreen numeric keypad buttons to type the PIN (11353008).
5. Touch OK to save the PIN or Cancel to exit the screen.
6. The PIN displays in the Service use only: text box as ********.
7. Touch OK to open the Service menu or Cancel to exit the screen.
The following menu items appear in the Service menu:
Menu item Sub-menu item Description
Clear Event Log Use this item to clear the product event log.
Mono Cycle Count The page count that is stored in NVRAM and printed on the
configuration page represents the number of pages that the
formatter has formatted (not including engine-test prints).
Color Cycle Count The page count that is stored in NVRAM and printed on the
configuration page represents the number of pages that the
formatter has formatted (not including engine-test prints).
Refurbish Cycle Count Use this item to record the page count when the product
was refurbished.
Document Feeder Kit Count: Set the total number of pages that have been fed through
the ADF.
Document Feeder Kit Interval Total number of pages since the document feeder kit was
replaced.
ADF Count Set the total pages fed through the ADF.
Flatbed Count Set the total pages scanned from the flatbed.
ADF Simplex Count Set the total single-sided pages fed through the ADF.
ADF Duplex Count Set the total two-sided pages fed through the ADF.
Copy Scan Count Set the total copy pages that have been scanned.
Send Scan Count Set the number of scanned pages sent to e-mail.
Copy Pages Count Set the number of scanned pages that have been printed.
ENWW Service mode functions 503
To Next Page
Loading...
