Page skew
Defect description
The printing is skewed on the page.
Possible causes
The ADF tray guides are not adjusted properly. The mylar strip is dislodged, folded, misinstalled, or
worn. The ADF rollers are dirty.
Troubleshooting and suggestions
1. Make sure the ADF input tray guides are adjusted so that they are lightly touching the sides of the
paper stack.
2. If the mylar strip is dislodged, folded, or misinstalled, verify it is correctly installed. If the mylar strip
is worn, replace it. Replacement mylar strips are stored in an envelope that is underneath the white,
vinyl ADF backing. Follow the instructions that are in the envelope.
3. Clean the ADF rollers.
4. If the problem persists, calibrate the scanner.
282 Chapter 16 Problem solving ENWW
To Next Page
Loading...