SpO2 Monitoring (Optional)
Using SpO2 to Monitor a Patient
6-3
Before you start SpO
2
monitoring:
1 Estimate the patient’s weight, and determine the best site for the sensor.
2 Use the Sensor Guide to select the correct type and size of sensor for the identi-
fied location.
3 Prepare the sensor:
m Disposable: Remove protective backing.
m Semi-Disposable: Apply a new adhesive wrap to the sensor.
4 Apply the sensor to the identified location.
5 Connect the sensor to the monitor. To connect sensors from other manufacturers
you need the HP M1900B Connector Cable.
Apply the Sensor to the Patient
HP supports the use of many sensors. Use the Sensor Guide to find the sensor which
is best for your case. Follow the manufacturer’s guidelines for applying and using
the sensor.
Semi-Disposable Semi-disposable sensors can be reused, but the
adhesive wrap must be discarded after each use.
Semi-disposable sensors are recommended for
single-patient use only.
Reusable Reusable sensors can be reused on different
patients.
To Next Page
Loading...
