EN
Control panel messages
9
1
The printer configuration page is being printed continuously.
• Press
C
ANCEL
J
OB
to terminate continuous configuration page
printing and return the printer to the
READY
state.
A density sensor out of range error was detected during a color
calibration.
• The density sensor may be dirty. Inspect and clean the sensor. See
“Cleaning the toner density sensor” in the service manual.
The printer has received and processed data and is waiting for a form
feed.
• Load the appropriate media to continue the print job.
The extended diagnostics power-up key sequence has been entered.
Refer to the diagnostics procedures provided in the service manual.
• No action is required.
An error has been detected with a component of the print drum kit.
• Replace the print drum kit.
Continuous page, press cancel job
Density sensor out of range
alternates with
Clean density sensor
Data received
Diagnostics mode
Drum error replace drum kit
To Next Page
Loading...