10 Chapter 1 Troubleshooting control panel messages
EN
Approximately 80% of the drum’s life has been consumed.
• Drum replacement will be required in the near future.
The imaging drum has reached the end of its expected life.
• Replace the print drum kit.
An error has occurred in the duplex-printing accessory.
• Verify that the duplex-printing accessory is correctly installed and
plugged in.
The EIO device in slot “x” is initializing. The yyy value will increment
every 10 seconds during this process.
• No action is required.
The EIO slot specified does not have a card installed or is not
functional.
• No action is required.
Drum life low replace drum kit
Drum life out replace drum kit
Duplexer error check duplexer
EIO x initializing yyy
alternates with
Do not power off
EIO x not functional
To Next Page
Loading...