EN
Control panel messages
11
1
SHOW EVENT LOG
was selected from the Information menu, but the
event log has no entries.
• No action is required.
Approximately 95% of the fuser’s life has been consumed.
• Fuser replacement will be required in the near future. Continue
printing, or replace the fuser kit.
The fuser has reached the end of its expected life.
• Replace the fuser kit.
The drum kit is not installed or is incorrectly installed.
• Verify that the drum kit is correctly installed.
The printer cannot print until media is loaded into Tray 2. The paper
path for Tray 3 passes through Tray 2.
• Insert Tray 2 into the printer so that printing from Tray 3 can begin or
continue.
Event log empty
Fuser life low replace kit
Fuser life out replace kit
Install drum kit
Install Tray 2
To Next Page
Loading...