12 Chapter 1 Troubleshooting control panel messages
EN
The printer has no available memory. The current job may not print
correctly. Some downloaded fonts may have been deleted.
• Try printing simplified pages. If this does not resolve the problem,
add printer memory.
The I/O buffering settings were changed by the printer because there is
not enough memory available to use the previous settings.
• No action is required. However, adding printer memory can prevent
this from occurring.
The available memory was not enough to continue printing. The
remainder of the job was canceled.
• Adding printer memory can prevent this from occurring.
The printer’s adaptive data compression had to resort to lossy
compression to fit raster graphics in the available memory. This has
caused a data loss in the raster output.
• Reduce the complexity of the page to improve the print quality.
Note
Adding memory will not correct this problem.
Memory full stored data lost
Memory settings changed
Memory shortage job cleared
Memory shortage page simplified
To Next Page
Loading...