EN
Control panel messages
13
1
C
ANCEL
J
OB
was pressed but there is no active job or buffered data to
cancel. The printer automatically returns to the
READY
state.
• No action is required.
An internal page has been requested while the printer is printing an
incoming job. Interrupting the job to print the internal page would
corrupt the job’s environment and potentially cause the job to finish
printing incorrectly after the internal page is completed. Consequently,
internal pages are not permitted to interrupt jobs and can only be
printed when the printer is idle.
• Retry print job after printer has completed current job.
The printer’s adaptive data compression had to resort to lossy
compression to fit raster graphics in the available memory. This has
caused a data loss in the raster output.
• Reduce the complexity of the page to improve the print quality.
Note
Adding memory will not correct this problem.
No job to cancel
Page cannot print now
alternates with
Retry when printing stops
Page simplified
To Next Page
Loading...