16 Chapter 1 Troubleshooting control panel messages
EN
The top output bin holds 200 sheets of paper. Sensor PS9 along with its
sensor flag detects the height of the output paper stack. Perform the
following items if this message appears with no paper in the output bin.
1 Verify that PS9 moves freely and its movement is not blocked.
2 Verify that PS9 is free of dust and debris (the printer’s top cover
must be removed to access the sensor).
3 Verify that the PS9 sensor flag and arm move freely.
4 Verify that all connectors are firmly seated. Refer to the wiring
diagram in chapter 10.
Note
PS9 (a three-wire sensor) plugs into a through-wall connector on the
printer’s chassis and then into a 14-pin wire harness, which plugs into
J206 on the developing PCB. All signals from the developing PCB are
routed to J201 on the developing PCB to J1017 on the DC controller
PCB.
The printer is executing a memory reset. The printer returns to the
READY
state upon completion of this process.
• No action is required.
The color calibration density values have been reset to their default
values.
• No action is required.
Remove paper top output bin
Resetting memory
Resetting values finished
To Next Page
Loading...