EN
Control panel messages
19
1
Media has been loaded into the tray specified on the control panel. The
most recently configured size will be displayed with an asterisk next to
it.
• Use
-V
ALUE
+
to view all possible sizes.
• Press
S
ELECT
for the currently displayed size.
• Press
G
O
to clear the message.
Media has been loaded into the tray specified on the control panel. The
most recently configured type will be displayed with an asterisk next to
it.
• Use
-V
ALUE
+
to view all possible sizes.
• Press
S
ELECT
for the currently displayed type.
• Press
G
O
to clear the message.
Waste toner full sensor PS13 detects a waste toner full condition. Light
receiver and light pipe arrangement along with a window in the drum
assembly look for a waste fill condition. Verify that the sensors and light
pipes are not blocked.
1
Replace the drum kit.
2
Check the sensor, and if it is defective, replace it.
Tray x size [size]
Tray x type [type]
Waste toner full replace drum kit
To Next Page
Loading...