EN
Control panel messages
27
1
This message indicates that a laser malfunction has occurred due to a
beam detect error or laser failure.
1
Turn the printer off and on to reset the printer.
2
Verify that connectors J1102 on the laser driver PCB and J1008 on
the DC controller are seated properly.
3
Verify that connectors J551 on the beam detect PCB and J1006 on
the DC controller are seated properly.
4
Replace the laser scanner assembly.
This message indicates that a scanner error has occurred.
1
Turn the printer off and on to reset the printer.
2
Verify that connectors J551 on the beam detect PCB, J1103 on the
scanner motor, and J1006 on the DC controller are fully seated and
connected correctly.
3
Replace the laser scanner unit.
51 Laser error
52 Scanner error
To Next Page
Loading...