28 Chapter 1 Troubleshooting control panel messages
EN
This message indicates a memory error. If a DIMM caused the error,
the DIMM will not be recognized (configured).
x = Memory Type
0 = ROM
1 = RAM
y = Device Location
0 = Onboard
1 = DIMM slot 1
2 = DIMM slot 2
3 = DIMM slot 3
zz = Error Number
0 = Unsupported memory
1 = Unrecognized memory
3 = Failed RAM test
1 Verify that the DIMM board is installed correctly and the DIMMs are
configured correctly.
2 Turn the printer off and on to reset the printer.
3 Remove and replace the DIMM that caused the error.
This message indicates that an internal power failure has occurred.
1 Turn the printer off, and then turn the printer on.
2 Replace the high-voltage power supply
53.xy.zz Printer error
54.1 Printer error control panel messages
To Next Page
Loading...