34 Chapter 1 Troubleshooting control panel messages
EN
This message indicates that there is a printer firmware problem. Either
there is no firmware DIMM installed or the DIMM has failed. If the
formatter was just replaced, make sure all DIMMS have been moved
from the old formatter to the new one.
1 Turn the printer off and on to reset the printer.
2 Reseat the firmware DIMM, making sure the it is in the slot
surrounded by a white line with the text “ROM ONLY IN THIS SLOT.”
This message indicates that a problem exists with the internal memory.
x = Description
0 = Internal memory
1-3 = DIMM slots 1-3.
1 Turn the printer off and on to reset the printer.
2 Reseat and then replace the DIMM.
3 Replace the formatter board.
The firmware ran out of memory trying to build the static entity directory.
1 Check the printer settings to determine which values have been
changed.
2 Clear the message by pressing G
O
.
62 No system
62.x Printer error
62.m Bad MPTR
To Next Page
Loading...