HP Color LaserJet 4500 - Page 41

EN
Control panel messages
35
1
One or more settings saved in the non-volatile storage device are
invalid. Some settings may have been reset to factory defaults.
1
Check the printer settings to determine which values have been
changed.
2
Clear the message by pressing
G
O
.
This message indicates that a non-volatile storage device is full. Some
settings may have been reset to factory defaults.
1
Check the printer settings to determine which values have been
changed.
2
Clear the message by pressing
G
O
.
A hardware error has occurred.
x = Description
01xx = IO ASIC register error
02xx = video ASIC register error
03xx = IDE ASIC register error
1
Reseat the formatter.
2
Reseat the firmware DIMM.
3
Run formatter diagnostics.
4
Replace the firmware DIMM.
5
Replace the formatter.
68 NVRAM error check settings
68 NVRAM full check settings
79 Service (xxxx) printer error