HP Color laserjet 5500 - Page 175

Issue Cause Solution
The printer Ready indicator light
is not lit.
Press PAUSE/RESUME to return
the printer to the Ready state.
The top cover is
not closed
properly.
Close the top co
ver firmly.
The Data indicator light is
flashing.
The printer is probably still
receiving data. Wait for the Data
indicator to stop flashing.
REPLACE <COLOR>
CARTRIDGE appears on
the printer display.
Replace the print cartridge
specified on the printer display.
A printer message other tha n
Ready appears on the printer
control panel.
See Control panel
messages.
The parallel port may have a
DOS timeout error.
Add a MODE command to
the AUTOEXEC.BAT file. See
the DOS manual for additional
information.
The PS (PostScript Emulation)
personality is not selected.
Select PS or AUTO for
the printer language. See
Changing printer control
panel configuration settings.
The correct driver is not sele c ted
in the software application or
printer d
river.
Select the driver for PostScript
Emulation for this printer in the
software
application or printer
driver.
The printer is not p roperly
configured.
See Changing printer control
panel configuration settings.
The computer port is not
configured or i s not working
properly.
Run another peripheral
connected to this port to
verify that the port is working
properly.
Printer is on, but nothing prints
The printer has not been
correctly named for the network
or for
aMacintosh.
Use the appropriate utility to
name the printer on the network.
For Ma
cintosh, name the printer
from within the Chooser menu.
EN_WW Printer response problems 168