Intermediate transfer belt (ITB)
1. Remove the following components:
●
Right cover. See
Right cover on page 132.
●
Left cover. See
Left cover on page 135.
●
Rear-side cover. See
Rear-side cover on page 142.
●
Print-cartridge drawer. See
Print-cartridge drawer on page 151.
2. Disconnect one wire-harness connector (callout 1), and then release the wire harness from the
retainer (callout 2).
Figure 6-75 Remove the ITB (1 of 5)
1
2
156 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...