HP Color LaserJet CM3530 MFP Series - Load Tray 2; Load Tray 1 (continued)

HP Color LaserJet CM3530 MFP Series – Manage and maintain
How do I? Steps to perform
Load Tray 1 (continued)
5 Adjust the side guides so that they lightly touch the
paper stack but do not bend it.
Load Tray 2
CAUTION: Do not print envelopes, labels, postcards, or
unsupported sizes of paper from the Tray 2. Print these
types of paper only from Tray 1.
6
7
8
Slide open the tray.
NOTE: Do not open the tray while it is in use.
Adjust the paper-length and paper-width guides by
squeezing the adjustment latch and sliding the
guides to the size of the paper being used.
Load paper into the tray face up. Check the paper to
verify the guides lightly touch the stack, but do not
bend it.
NOTE: To prevent jams, do not overfill the tray. Be
sure the top of the stack is below the tray full
indicator.
NOTE: If the tray is not adjusted correctly, an error
message might appear during printing or the paper
might jam.
2
© 2008 Copyright Hewlett-Packard
www.hp.com
Development Company, L.P.