Right panel
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 111.
●
Upper-cover assembly. See
Upper-cover assembly on page 121.
●
Control-panel assembly. See
Control-panel assembly on page 124.
2. Disconnect one connector (callout 1; J206) on the DC controller.
Figure 6-89 Remove the right panel (1 of 8)
1
3. Remove three screws (callout 2).
Figure 6-90 Remove the right panel (2 of 8)
2
136 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...