Connecting the Hardware 5
5. If you have a printer cable attached to the computer’s parallel port,
disconnect it from the computer and plug it into the tape drive’s
connector shown below.
The data cable that came with your drive attaches to the computer’s
parallel port and the tape drive’s remaining 25-pin connector.
6. Attach the tape-drive data cable to your computer’s parallel port and
hand tighten the connector’s retaining screws.
Secure the connector
by tightening the
retaining screws.
Drive’s power connector
Printer connector
Printer’s data cable
(If a printer is sharing
the parallel port with
the tape drive)
Attach this end to
the tape drive.
Attach this end to the
computer’s parallel port.
Tape-drive data cable
To Next Page
Loading...
