10,000 RPM Serial ATA
Hard Drives
80-GB
Capacity
80,026,361,856 bytes
Height
1 in (2.54 cm)
Width
Media diameter: 2.5 in (? cm)
Physical size: 4 in (10.2 cm)
Interface
Serial ATA (1.5 Gb/s), Native Command Queuing enabled
Synchronous Transfer
Rate
(Maximum)
Up to 3.0 Gb/s
Cache
16 Mbytes
Seek Time
(typical reads,
includes controller
overhead, including
settling)
Single Track
0.3 ms
Average
4.6 ms
Full-Stroke
10.2 ms
Rotational Speed
10,000 rpm
Logical Blocks
156,301,488
Operating Temperature
41° to 131° F (5° to 55° C)
64 GB Solid State Drive
Capacity
64 GB
NAND Flash Memory
Multi Level Cell (MLC) with wear leveling controller
Interface type
SATA 3Gb/sec
Dimensions-external
(W x H x D)
2.74 x 0.37 x 4 in (6.98 x 0.95 x 10.2 cm)
Weight
0.14 lb (65 g)
Internal transfer rate
Write speed
Up to 220 MB/s
Read speed
Up to 120 MB/s
Host transfer rate
Ultra DMA mode
Up to 150 MB/s
Power
DC power requirement
5 VDC 5%-100 mV ripple p-p
Total power consumption
<1.12Watt
Environmental
(all conditions, non-
condensing)
Temperature
(operating)
32° to 158° F (0° to 70° C)
Relative Humidity
(operating)
5% to 95%
Maximum Wet Bulb
Temperature
(operating)
84° F (29° C)
Regulations
UL, CSA, EN 60950-2000, CISPR Pub 22 Class B, CNS 13438, AS/NZS CISPR
22:2002 Class B, R1113 and C1172 Class B
* For solid state disk drives, GB means 1 billion bytes. 16GB is the unformatted capacity of this drive
before a portion of the drive is reserved for flash management features. Actual capacity varies by content
and will be less than 15.8GB.
QuickSpecs
HP Compaq 6000 Pro Business PC
Technical Specifications - Internal Storage
DA - 13411 North America — Version 24 — October 19, 2011
Page 42
To Next Page
Loading...
