HP Compaq dc5100 MT User Manual

2–22 www.hp.com Hardware Reference Guide
Hardware Upgrades
6. If replacing or adding a new expansion card, hold the card just
above the expansion slot on the system board then move the card
toward the rear of the chassis 1 so that the bracket on the card is
aligned with the open slot on the rear of the chassis. Gently press
the card straight down into the expansion slot on the system
board 2.
Replacing or Adding an Expansion Card
✎
When installing an expansion card, press firmly on the card so that
the whole connector seats properly in the expansion card slot.
7. If you are replacing an expansion card, store the old card in the
anti-static packaging that contained the new card.
376292-001.book Page 22 Friday, February 18, 2005 2:42 PM

HP Compaq dc5100 MT Specifications

General

Memory	Up to 4 GB DDR2 SDRAM
Memory Slots	4 DIMM slots
Hard Drive	Up to 160 GB SATA
Network	Integrated Broadcom NetXtreme Gigabit Ethernet
Operating System	Windows XP Professional
Form Factor	Microtower
Processor	Intel Pentium 4
Chipset	Intel 915G
Optical Drive	CD-ROM, DVD-ROM
Graphics	Intel GMA 950
Audio	Integrated AC'97 audio
Expansion Slots	1 PCI Express x16, 3 PCI
Ports	1 serial, 1 parallel, audio in/out