EasyManuals Logo

HP Compaq dx2450 MT User Manual

HP Compaq dx2450 MT
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
Memory
The computer comes with double data rate 2 synchronous dynamic random access memory (DDR2-
SDRAM) dual inline memory modules (DIMMs).
The memory sockets on the system board can be populated with up to four industry-standard DIMMs.
These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum
memory support, you can populate the system board with up to 4 GB of memory configured in a high-
performing dual channel mode.
For proper system operation, the DDR2-SDRAM DIMMs must be:
industry-standard 240-pin
unbuffered, PC2-5300 667 MHz-compliant or PC2-6400 800 MHz-compliant
1.8 volt DDR2-SDRAM DIMMs
The DDR2-SDRAM DIMMs must also:
support CAS latency 5 DDR2 667 Mhz (5-5-5 timing), CAS latency 5 DDR2 800 Mhz (5-5-5 timing),
and CAS latency 6 DDR2 800 Mhz (6-6-6 timing)
contain the mandatory JEDEC SPD information
In addition, the computer supports:
512Mbit and 1Gbit non-ECC memory technologies
single-sided and double-sided DIMMs
DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not
supported
NOTE: The system will not operate properly if you install unsupported DIMMs.
There are four DIMM sockets on the system board, with two sockets per channel. The sockets are
labeled XMM1, XMM2, XMM3, and XMM4. Sockets XMM1 and XMM2 operate in memory channel A.
Sockets XMM3 and XMM4 operate in memory channel B.
36 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dx2450 MT and is the answer not in the manual?

HP Compaq dx2450 MT Specifications

General IconGeneral
BrandHP
ModelCompaq dx2450 MT
CategoryDesktop
LanguageEnglish

Related product manuals