Service Reference Guide 483941-001 2–5
Setup Utilities and Diagnostics Features
Standard
CMOS
Features
(continued)
SATA Port 0
SATA Port 1
SATA Port 2
SATA Port 3
For each, allows you to:
• IDE Channel 0 Master (for SATA Port 0 Only)
• IDE Channel 1 Slave (for SATA Port 1 Only)
• detect HDD size and head on selected
channel
• set extended drive on selected channel to (for
SATA Port 2 and port 3 only):
•None
•Auto
• set access mode on selected channel to:
•CHS
•LBA
•Large
•Auto
•view:
•Capacity
•Cylinder
•Head
•Precomp
•Landing Zone
•Sector
Legacy Mode Support
(for SATA 0/1 ONLY)
Disable
Enable
Halt On Allows you to set at:
• All Errors
•No Errors
• All but Keyboard
• All but Diskette
• All but Disk/Key
Advanced
BIOS Features
F11 Prompt Allow you to enable or disable this feature.
Quick Power On Self Test Disables/enables the system to skip certain
tests while booting.
Enabling this feature decreases the time
required to boot the system.
POST Delay Time (seconds) Allows you to set a POST delay time to:
•0 Sec
•5 Sec
• 10 Sec
• 15 Sec
• 20 Sec
Computer Setup (Continued)
Heading Option Description
✎
Support for specific Computer Setup options may vary depending on the hardware
configuration.
To Next Page
Loading...
Need help?
General