6–6 483941-001 Service Reference Guide
Removal and Replacement Procedures— Microtower (MT)/Small Form Factor (SFF) Chassis
6.3 Using the Small Form Factor Computer in a
Minitower Configuration
The Small Form Factor computer can be used in either a minitower or desktop configuration. To
use it in the minitower configuration, you must purchase a tower stand from HP (part number
316593-001).
Ä
CAUTION: If the computer is in the desktop configuration, ensure at least 4 inches (10.2 cm) of space
on all sides of the computer remains clear and free of obstructions.
To install the tower stand:
1. Rotate the computer into the tower position 1 and align the hole at the base of the computer
with the post and thumbscrew in the stand 2.
2. Tighten the screw to secure the computer to the stand 3 . This adds stability and helps to
ensure proper airflow to the internal components.
Installing the Tower Stand
To Next Page
Loading...
Need help?
General