Power
Source
Four-pin, DC power receptacle
DC Power Requirement
5 VDC ± 5%-100 mV ripple p-p
DC Current
5 VDC - <1000 mA typical, < 1600 mA maximum
Total Drive Power
(standby mode)
< 2.5 Watt
Audio output
Line-Out
0.7 VRMS
Signal-to-Noise Ratio
74 dB
Channel Separation
65 dB
Environmental
(all conditions
non-condensing)
Temperature
41° to 122° F (5° to 50° C)
Relative Humidity
5% to 85%
Maximum Wet Bulb
Temperature (operating)
86° F (30° C)
HP 22-n-1 Media Card Reader
USB Interface
USB 2.0 High-speed interface
Note:
Requires the USB cable to be connected to the internal USB 2.0 port or a USB 2.0 PCI card.
Advance protocol support
Supports hardware ECC (Error Correction Code) function
Supports hardware CRC (Cyclic Redundancy Check) function
Supports MS 4-bit parallel transfer mode
Supports MS-PRO 4-bit parallel transfer mode
Supports MS PRO-HG Duo 4-bit parallel transfer mode
Supports SD 4-bit parallel transfer mode
Supports high-speed 50Mhz SD 4-bit card (version 2.0)
Supports high-speed 52Mhz MultiMediaCard 8-bit card (version 4.2)
Supports CF v4.0 with PIO mode 6 and Ultra DMA mode
CompactFlash Type I
CompactFlash Type II
Microdrive
MultiMediaCard
Reduced Size MultiMediaCard (RS MultiMediaCard)
MultiMediaCard 4.2 (MultiMediaCard Plus, including MultiMediaCard Plus HC)
QuickSpecs
HP Compaq Elite 8300 Business PC
Technical Specifications - Removable Storage
DA - 14268 North America — Version 41 — November 22, 2013
Page 46
To Next Page
Loading...
