HP Compaq NC4000 - Installing the Operating System and System Software; Preparing for Installation; Installing Drivers and Enhancements

4
Installing SP2 and system software updates
Preparing for installation -- installing drivers and enhancements
IMPORTANT
Upgrade the system ROM before beginning the Windows XP Service Pack
2 installation.
Drivers and enhancements installation
Perform the following steps:
1. If necessary, unbundle the preinstalled image. (Refer to the documentation included with the
system for instructions.)
2. Install SP2 (See note below).
Note
Contact the Network Administrators to properly set up the networking and
security components of Microsoft Windows SP2. Refer to the Microsoft
website for complete SP2 installation instructions.
3. Install the updated drivers and enhancements from the HP Software Support CD or the HP website
at http://www.hp.com/support/files
. See Table 1 for additional information.
Table 1 Minimum Versions of Necessary Drivers and Enhancements (along with recommended installation order)
Windows XP SP2 software
components
Platforms Version
Support Software for Bluetooth
by hp
All supported platforms
3.00 C
Support Software for Bluetooth
MultiPort Module
All supported platforms
3.00 B
Quick Launch Button Software
All supported platforms
5.00 A
System Enhancements for SP2
All supported platforms
1.00 A
4. Restart the notebook PC.