HP Compaq NC6320 - Set up the Computer

First-time setup
Set up the computer
Ä
CAUTION: To prevent file corruption and to ensure that the correct drivers
are installed:
■� Do not set up the computer for the first time while the computer
is docked in an optional docking device.
■� During the hardware and software setup procedures:
❏� Do not unplug the computer from external power.
❏� Do not shut down the computer or initiate standby
or hibernation.
✎
Your computer may look slightly different from the
illustrations in this section.
When setting up the computer, you will
1. Insert the battery pack into the computer so that it can begin
to charge as soon as the computer is connected to external
power.
2. Connect the computer to external power.
3. Turn on the computer.
4. Set up the software.
5. Create recovery discs.
1–14 Getting Started