Removal and Replacement Procedures
Maintenance and Service Guide 5–35
6. Turn the computer display-side up with the front toward you.
7. Open the computer as far as possible.
Ä
CAUTION: Support the display assembly when removing the following
screws. Failure to support the display assembly can result in damage to
the display assembly and other computer components.
8. Disconnect the display cable 1 from the system board.
9. Remove the wireless antenna cables 2 from the clips in the
top cover.
10. Remove the two Torx8 T8M2.5×9.0 screws 3 that secure
the display assembly to the computer.
11. Lift the display assembly 4 straight up and remove it.
Removing the Display Assembly
Reverse the above procedure to reassemble and install the
display assembly
To Next Page
Loading...
