Troubleshooting
Maintenance and Service Guide 2–3
Computer Setup Defaults
To return all settings in Computer Setup to the values that were
set at the factory:
1. Open Computer Setup by turning on or restarting the
computer, and then pressing
f10 while the “F10 = ROM Based
Setup” message is displayed in the lower-left corner of the
screen.
In Computer Setup, the following shortcuts are available:
❏ To change the language, press f2.
❏ To view navigation information, press f1.
❏ To close open dialog boxes and return to the main
Computer Setup screen
esc.
2. Use the arrow keys to select File > Restore defaults, and
then press
enter.
3. When the confirmation dialog box opens, press
f10.
4. Select the Restore defaults check box, and then press
enter.
5. To confirm the restoration, press
f10.
6. To save your preferences and exit Computer Setup, use the
arrow keys to select File > Save Changes and Exit. Then
follow the instructions on the screen.
Your preferences go into effect when the computer restarts.
✎
Your password and security settings are not changed when you
restore the factory default settings.
To Next Page
Loading...
