Removal and Replacement Procedures
Maintenance and Service Guide 5–47
2. Position the computer with the rear panel toward you.
3. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable 1 from the system board.
4. Remove the Phillips PM2.0×3.0 screw 2 that secures the
USB/audio board to the base enclosure.
5. Remove the cable from the clips 3 in the base enclosure.
6. Remove the USB/audio board 4.
7. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable 5 USB/audio board.
Removing the USB/Audio Board
Reverse the above procedure to install the USB/audio board.
To Next Page
Loading...
