Slow sync.
This would be used to capture a dimly lit background while keeping the foreground (subject) properly lighted. This
flash mode forces the camera to use a slower shutter speed in combination with the flash. The flash fires briefly to
light the foreground (subject) while capturing ambient light to reveal more detail in the background. If Slow Sync
flash is not used, the background may appear black or underexposed.
Forced off.
The flash is turned off and will not fire regardless of the lighting situation. In low light situations, the use of a tripod
may be required to reduce photo blurring.
Flash function is only available in shooting still images but not available in Burst •
and AEB modes.
Donottrytochangetheashwhilepressingthezoombutton.Changetheash•
after releasing the zoom button if necessary.
Setting the Focus Mode
This function allows users to define the type focus when recording a still image or a video clip.
To set the Focus mode
Press the • Macro button repeatedly until the desired focus mode icon is displayed on the lower left corner of the
LCD monitor.
Macro/left button
This camera supports the following four focus modes:
Normal.
With normal focus, the focus range starts from 0.4m (about
16 inches) to near infinity. When the camera is set to Normal
mode, there is no icon displayed on the screen.
Macro.
This mode is designed for close-up photography. This mode
should be used for subjects closer that are 0.4 m (or 16
inches) from the lens. If Macro is enabled, the camera can
capture the detail and sharpness of a very close subject by
fixed focus.
Macro enabled
To Next Page
Loading...
Need help?
General
