Desktop Management Guide www.hp.com 21
Desktop Management Guide
12. Turn off the computer and unplug the power cord. Open the
computer and re-install any PCI cards that were previously
removed. Close the computer cover.
13. Plug in the power cord, remove the diskette, and turn on the
computer.
14. As soon as the computer is turned on, press
F10 when the
monitor light turns green to enter Computer Setup. Press
Enter to
bypass the title screen, if necessary.
15. Go to Advanced > PCI Devices and re-enable the PATA and
SATA controllers that were disabled in step 6. Put the SATA
controller on its original IRQ.
16. Save the changes and exit. The computer will boot to the USB
flash media device as drive C.
✎
The default boot order varies from computer to computer, and it can
be changed in the Computer Setup (F10) Utility. Refer to the
Computer Setup Guide on the Documentation and Diagnostics CD
for instructions.
If you have used a DOS version from Windows 9x, you may see a
brief Windows logo screen. If you do not want this screen, add a
zero-length file named LOGO.SYS to the root directory of the USB
flash media device.
Return to “Copying to Multiple Computers” on page 16.
To Next Page
Loading...
